Научная электронная библиотека ULRICH'S Periodicals Directory

Сибирский государственный университет
науки и технологий имени академика М.Ф. Решетнева

Сибирский аэрокосмический журнал
ISSN 2712-8970 (Print) ISSN 2782-5760 (on-line)

Сведения об образовательной организации

UDK 539.374 Doi: 10.31772/2587-6066-2018-19-3-438-444
MODELING OF PLASTIC FLOW BETWEEN RIGID PLATES APPROACHING TO A CONSTANT ACCELERATION
S. I. Senashov*, E. V. Filyushina
Reshetnev Siberian State University of Science and Technology, 31, Krasnoyarsky Rabochy Av., Krasnoyarsk, 660037, Russian Federation. *E-mail sen@sibsau.ru
In this paper we study equations describing a slow plastic flow of material. In this case the material is in the flat state of stress. The paper presents the equations that can be used to simulate slow plastic material flows compressed between rigid plates, converging with constant acceleration. In the above equations we neglect convective terms, which greatly simplifies all calculations. The Lie algebra of point symmetries admitted by these equations is calculated for reduced equations. It has dimension eight. The optimal system of one-dimensional subalgebras is constructed for this algebra. It allows to give a view of all the different invariant solutions of rank two. That means such solutions depend only on two independent variables. To demonstrate this we offer a table of switches of all basis operators, as well as a table of all internal automorphisms functioning. One of the solutions, which simulates the slow plastic flow of the material compressed between rigid plates, converging with constant acceleration, built in. Among the most popular solutions in the flat theory of ideal plasticity is the Prandtl’s solution, which describes the compression of a plastic layer between rigid plates. In this case, the plates approach at a constant speed. The popularity of the solution is explained by its simplicity, as well as the fact that it can be used to describe various technological processes. The analogue of such a solution for the plane stress state cannot be constructed. In general, there are big problems with finding analytical solutions for the plane state of stress. It is caused by the fact that the equations describing this state are quite complex, even in spite of their linearization. In one of the previous works, one of the authors of the present article managed to find a solution that describes compression of a plastic layer between rigid plates which converge with constant acceleration. In this work the analogue of such a solution is found for the plane stress state. The authors hope that the suggested solution can also be used for the analysis of real technological processes.
Keywords: plane stress, the exact solution, non-stationary process.
References

1. Ivlev D. D., Senashov S. I., Maksimova A. A., Nepershin R. I., Radaev Yu. N., Shemyakin E. I. Predelnoe sostoyanie deformirovannyih tel i gornyih porod [Limiting state of deformed bodies and rocks]. Moscow, Fizmatlit Publ., 2008, 832 p. (In Russ.).

2. Senashov S. I., Vinogradov A. M. Symmetries and conservation laws of 2-dimensional ideal plasticity. Proceedings of the Edinburgh Mathematical Society. 1988, Vol. 31, No. 3, P. 415–439.

3. Senashov S. I., Yakhno A. Reproduction of solutions of bidimensional ideal plasticity. International Journal of Non-Linear Mechanics. 2007, Vol. 42, No. 3, P. 500–503.

4. Senashov S. I., Yakhno A. Some symmetry group aspects of a perfect plane plasticity system. Journal of Physics A: Mathematical and Theoretical. 2013, Vol. 46, No. 35, P. 355202.

5. Senashov S. I., Yakhno A., Yakhno L. Deformation of characteristic curves of the plane ideal plasticity equations by point symmetries. Nonlinear Analysis. 2009, Vol. 71, No. 12, P. 1274–1284.

6. Kovalev V. F., Pustovalov V. V., Senashov S. I. Lie-Backlund symmetry of nonlinear geometrical optics equations. Differential Equations. 1993, Vol. 29, P. 1521–1531.

7. Senashov S. I., Yakhno A. Cauchy problem solution for a hyperbolic system of the homogeneous 2-dimensional quasilinear equations. Vestnik SibGAU. 2009, No. 4 (25), P. 26–28 (In Russ.).

8. Senashov S. I. [On a class of exact solutions of the equations of ideal plasticity]. Zhurnal prikladnoy mehaniki i tehnicheskoy fiziki. 1986, No. 3, P. 139–142 (In Russ.).

9. Senashov S. I., Burmak V. I. [Exact solution of the equations of plasticity of a plane stress state]. Vestnik SibGAU. 2010, No. 4 (30), P. 10–11 (In Russ.).

10. Senashov S. I., Yakhno A. The 2-dimensional plasticity: boundary problems and conservation laws, reproduction of solutions. Proceedings of Institute of Mathematics of NAS of Ukraine. 2004, Vol. 50, P. 231–238.

11. Gomonova O. V., Senashov S. I. New exact solutions which describe 2-dimensional velocity field for Prandtl's solution. Vestnik scientific journal of Siberian Aerospace University. 2009, No. 5(26), P. 43–45.

12. Senashov S. I. [On the evolution of the Prandtl solution under the action of the symmetry group]. Izvestiya Rossiyskoy akademii nauk. Mehanika tverdogo tela. 2005, No. 5, P. 167–171 (In Russ.).

13. Senashov S. I., Gomonova O. V. [New velocity fields describing the compression of the plastic layer between the plates]. Vestnik Chuvashskogo gosudarstvennogo pedagogicheskogo universiteta im. I. Ya. Yakovleva. Seriya: Mehanika predelnogo sostoyaniya. 2012, No. 4 (14), P. 89–95 (In Russ.).

14. Senashov S. I., Savostyanova I. L., Filyushina E. V. [Exact solutions of the equations of ideal plasticity in the case of a plane stress state]. Materialyi XXI Mezhdunar. Nauch.- prakt. Konf. “Reshetnevskie chteniya”. 2017, No. 21-2, P. 31–32 (In Russ.).

15. Annin B. D., Byitev V. O., Senashov S. I. Gruppovyie svoystva uravneniy uprugosti i plastichnosti [Group properties of the equations of elasticity and plasticity]. Novosibirsk, Nauka Publ., 1985, 150 p.


Senashov Sergey Ivanovich – Dr. Sc., professor, head of Department of Information Economic Systems, Reshetnev Siberian State University of Science and Technology. E-mail: sen@sibsau.ru.

Filyushina Elena Vladimirovna – Cand. Sc., Docent, Department of Information Economic Systems, Reshetnev Siberian State University of Science and Technology. E-mail: filyushina@sibsau.ru.


  MODELING OF PLASTIC FLOW BETWEEN RIGID PLATES APPROACHING TO A CONSTANT ACCELERATION